
smartDIYs
- Total activity 362
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 1
- Subscriptions 210
Activity overview
Latest activity by smartDIYs-
smartDIYs created an article,
"Limit switch error" is displayed
When the laser head is close to the origin Since the laser head is in contact with the limit switch, the error will be cleared when "Return to origin" is selected. When the laser head is not near t...
-
smartDIYs created an article,
There is a difference in cutting ability between X and Y
If a slight obstacle occurs in the movement of the axis due to physical factors (changes in the adjustment state due to impact or vibration on the movable axis, adhesion of foreign matter to the ra...
-
smartDIYs created an article,
Noise is heard from the laser head or exhaust fan
If the fan improves after a few minutes of running The bearing oil may solidify due to a drop in temperature, causing an abnormal noise. If the temperature rises and the oil becomes softer, the abn...
-
smartDIYs created an article,
Laser power suddenly weakened
Due to the characteristics of diode lasers, the laser power becomes weaker over time as the laser is used. It is recommended that you replace the laser head if it becomes weak. However, if the lase...
-
smartDIYs commented,
Hi Clell, are you operating with the lid open? If so, the laser will not fire as a safety precaution. If that's not the case, please shoot us an email!
-
smartDIYs created an article,
Cannot click the camera icon
When the door is closed, the camera icon is not clickable. Please open the door.
-
smartDIYs created an article,
Cannot connect to the Internet while operating with a smartphone or tablet
When connected to the Etcher Laser via a smartphone or tablet, it is not possible to connect to the Internet because it is connected directly via Wi-Fi. If you are using a Wi-Fi router, you can con...
-
smartDIYs created an article,
The captured image of the camera is different from the processing result
If the captured image of the camera does not match the position of the actual processing result, you can correct it in the software. In the case of PC software, the X-axis and Y-axis values can be ...
-
smartDIYs created an article,
An error occurs when using the camera (capture)
If the camera cannot recognize the camera marker attached to the processing bed, an error will occur. Please check the following issues: The laser head has not returned to the origin The material ...
-
smartDIYs created an article,
High sound from laser head
In rare cases, the laser head may resonate and produce a high-pitched sound (this has no effect on processing). The Etcher Laser already comes with one height adjustment screw, but you can stop the...